Post Date:12,Oct,2026
1. Influence of Cement Composition
Factors such as mineral composition, alkali content, type and dosage of supplementary cementitious materials (SCMs), form and dosage of gypsum, particle morphology, particle size distribution, and specific surface area all affect the rate of slump loss. The general trends are as follows:
(1) Cements with high C3A content (>8%), high alkali content (>1%), or high specific surface area accelerate the rate of slump loss.
(2) Slump loss becomes difficult to control or accelerates when anhydrite is used as the set regulator, when partial conversion of dihydrate gypsum to hemihydrate or anhydrite occurs during grinding, or when the sulfur trioxide (SO3) content is insufficient.
(3) SCMs with high reactivity or high water demand increase the rate of slump loss, whereas those with low water demand (e.g., limestone powder, slag, and fly ash) result in less loss.
(4) Suboptimal particle morphology, composition, and distribution (influenced by mill type and grinding process) accelerate slump loss.
(5) Cement with a high discharge temperature (specifically bulk cement) accelerates slump loss.
2. Influence of Free Water Content
Cement paste contains chemically bound water, adsorbed water, and free water; the presence of free water imparts fluidity to the paste. The proportions of these three types of water change during cement hydration. Upon the addition of water, C3A begins to hydrate, consuming a significant amount of water to form chemically bound water. As initial hydration proceeds, a large amount of gel is produced, vastly increasing the specific surface area of the dispersion and generating substantial adsorbed water (gel water) through surface adsorption. The formation of bound and adsorbed water depletes free water, causing a gradual reduction in paste fluidity—a phenomenon known as slump loss over time. The use of composite water-reducing admixtures to disperse particles and control the hydration process can reduce the amounts of bound and adsorbed water while correspondingly increasing free water, thereby mitigating fluidity loss.
3. Influence of Supplementary Cementitious Materials (SCMs)
The influence of SCMs on the slump loss of flowable concrete manifests primarily in three aspects:
(1) The water requirement ratio of the SCM should be less than 100%; otherwise, slump loss occurs more rapidly;
(2) The reactivity of the SCM should be moderate; high reactivity accelerates slump loss;
(3) The fineness of the SCM should be moderate; an excessively high specific surface area increases the concrete’s water demand and accelerates slump loss.
(4) Concrete mixtures prepared with SCMs having a low SO3 content exhibit significant slump loss.
Post time: Oct-12-2026

