Post Date:31,Aug,2026
1. Cement Fineness: Cement hydration is a reaction process between cement clinker and water, during which the continuous formation of hydration products consumes the liquid phase. Research by Wen Hanmei indicates that during hydration, clinker particles sized 3–30 μm primarily contribute to strength gain, whereas particles larger than 60 μm contribute nothing to strength; particles smaller than 10 μm mainly contribute to early strength, and those smaller than 3 μm contribute *only* to early strength. Particles smaller than 10 μm have a high water demand. For cement with good rheological properties, the content of particles smaller than 10 μm should be less than 10%. The finer the particles—and the higher the proportion of fine particles—the greater the water demand and early strength, which inevitably exacerbates slump loss. Simultaneously, as hydration proceeds, the solid phase increases and solid particles interconnect, leading to a loss in concrete slump. Therefore, concrete fluidity is closely linked to the cement hydration process: the faster the hydration rate, the greater the slump loss. Under identical conditions, finer cement particles result in higher water demand and more vigorous hydration reactions, inevitably causing slump loss in fresh concrete. Furthermore, finer cement implies a greater number of particles; at a constant water-cement ratio, the inter-particle distance is reduced, allowing hydration products to easily interconnect and thereby causing slump loss.
2. Aluminate mineral components exhibit a higher adsorption capacity for water-reducing admixtures than silicate minerals; the greater the adsorption, the poorer the compatibility. Concrete slump loss increases significantly as the tricalcium aluminate (C3A) content rises. In cements with high aluminate content—particularly high C3A content—C3A adsorbs polycarboxylate-based water reducers, thereby interfering with the adsorption of these admixtures by the silicate minerals tricalcium silicate (C3S) and dicalcium silicate (C2S). Additionally, research by Liu Houfen et al. indicates that C3A generates high heat of hydration and reacts rapidly, factors that readily lead to slump loss and reduced water-reduction efficiency.
3. Slump loss is significant at higher temperatures. Furthermore, the magnitude of slump loss is directly proportional to the initial slump; the higher the initial slump, the greater the loss. Therefore, it is not advisable to compensate for anticipated slump loss by increasing the initial slump during the mix design stage.
Post time: Aug-31-2026

